About this Event
During this workshop you will create your own photo board that lights up. You will engrave the acrylic with your own picture on the laser cutter, solder the electronics and put everything together.
Registration
This is an event for ETH students and can host 12 participants. The amount of particpants is limited to give you personalized support. Please register only if you are sure you can come on the day and time indicated. If something happens and you cannot come, cancel your registration as soon as possible. Please do not cancel last minute!
Requirement: General introduction
Make sure that you have attended the General introduction of the Makerspace before comming to the workshop. General Introductions take place every Makerspace Open Hour at 16:30-17:00 and 18:30-19:00 (12:30 and 14:30 on Saturday), no prior sign-up is required.
Check https://sph.ethz.ch/makerspace#OpenHours to find the next Open Hour.
Requirement: Lasercutter introduction
Make sure that you have attended the machine introduction and have recently used the Lasercutter at least once before comming to the workshop.
Check https://sph.ethz.ch/makerspace#introductions to find the upcoming machine introductions.
Preparation
If you want to have a custom image on your photo board, you can bring a USB-stick with a black and white image (preferably a line drawing).
Event Venue & Nearby Stays
SPH - FHK, D-Floor, Clausiusstrasse 16, Zürich, Switzerland
GBP 0.00